Page History

...

1. Go to "Device" then "Setup" and click “Import Named Configuration”:
   Image Removed
   Image Added
   
   

   Browse to the configuration backup file and click “OK”:
   Image Removed
   Image Added
   
   Click “Close” after the configuration is saved:
   Image Removed
   Image Added
   
   

2. While on the same page (Device > Setup), click “Load named configuration snapshot” and select the imported configuration backup file and click “OK”:
   Image Removed
   Image Added
   
   

   Click on “Close” to close the notification window:
   Image Removed
   Image Added
   
   

3. Once the configuration is loaded, you can revise different sections in the User Interface, such as Policies, Objects, Network, and then commit (apply) the configuration by clicking “Commit” on the top right corner and again click “Commit” on the pop-up window:
   Image Removed
   Image Added
   
   When the commit is completed, a status pop-up window shows the result. Take note of the warnings and any other information which needs attention later, then click “Close”. At this time, service should be restored:
   Image Removed
   Image Added